Mechanical seal failure may occur during the use of slurry pump, so what are the causes of this phenomenon? Generally, there are three reasons. 1. Water leakage during assembly: the submerged slurry pump is prone to problems during installation. Generally, it is necessary to observe whether the slurry pump leaks through static pressure test. When the leakage is small, there is something wrong with the moving ring or static ring seal ring in small shift. If the leakage is large, there is something wrong with the friction pair of the dynamic and static rings. The leakage medium is sprayed along the axial direction, which is mostly the problem of moving ring seal. If the leakage medium is sprayed or leaked from around the water cooling port, most of the static ring seals have problems. At this time, we should observe carefully, identify problems and make timely adjustments. 2. Leakage during trial operation: After the static pressure test, the leakage of slurry pump is generally caused by the damage of the friction pairs of moving and static rings. There are many reasons for this phenomenon, such as cavitation, vacuumizing, pressure maintaining, excessive compression during installation and sealing, axial force caused by abnormal phenomena such as tight or loose sealing ring of moving ring or static ring, etc., and particles in medium entering friction pair during work. The main solution is to disassemble and replace the seal again. 3. Sudden leakage during normal operation: In this case, a few cases are caused by normal wear or the slurry pump reaches its service life, but most of them are caused by changes in working conditions or improper operation and maintenance. The main reasons are as follows: emptying cavitation or pressure maintaining for a long time, the actual output is too small, the sealing cooling water is interrupted, the car is stopped for a long time, the substances in corrosion, polymerization or gel medium increase, the working environment temperature of slurry pump changes drastically, and the working conditions are frequently adjusted. In the process of using slurry pump, please pay attention to the usage specifications. The shaft seal water must be connected before use, and the pump can be stopped after five minutes. If it is not used for a long time, clean the pump cavity and mechanical seal with clear water before stopping operation. Turn the car manually when restarting to prolong the service life of slurry pump. Hebei Yingdike Pump Industry Group Co., Ltd. is a professional manufacturer of slurry pumps, submersible slurry pumps and sand suction pumps. It is an enterprise integrating research, development and production in Hebei Province.